Problem summary
Water pooling or dripping from underneath your Nordmende DF62 dishwasher is a sign that water is escaping from the tub or its seals during a cycle. This needs prompt attention, as standing water can damage flooring and create slip hazards.
Likely causes
Based on repair patterns for this model, the most common sources of leaks are:
Door seal degradation (most frequent)
The rubber gasket around the door edge can perish, crack, or become misaligned with age. When the seal fails to create a watertight contact, water seeps out during wash cycles.
Door lock mechanism fault
If the door latch does not engage fully or the lock release is faulty, the door may not close properly. This breaks the seal and allows water to escape, often from one side of the door.
PCB (control board) malfunction
Electrical faults in the control board can cause the inlet or drain valves to operate incorrectly, leading to water ingress or retention issues that result in leaks.
Why this needs an engineer
The parts involved in stopping leaks—door seals, door locks, and control boards—require either replacement or electrical diagnosis that goes beyond safe DIY territory. Attempting to dismantle the door mechanism or access internal components risks damaging the appliance further and may void any remaining cover.
Additionally, if water is leaking from the base of the unit rather than the door edge, the issue may involve the sump, pump, or internal plumbing connections, which are sealed systems and should not be opened without proper training.
When to call SMC Services
Contact a qualified engineer if you notice: - Water pooling underneath or around the dishwasher - Water dripping during a wash cycle - Visible damage to the door gasket or visible gaps when the door is closed - Water leaking consistently from the same spot - Any burning smells or electrical faults alongside the leak
Repairs typically involve replacing the door seal, adjusting or replacing the door lock assembly, or testing and replacing the control board. Our engineers will diagnose which part is responsible before recommending a fix.
If you're in Northern Ireland, SMC Services can usually book a repair within 2–3 working days.